Screen printing is a workhorse metallization process in solar cell manufacturing, but it can introduce degradation that affects device performance. The issue is especially relevant for copper-plated silicon heterojunction (HJT) solar cells, which are seen as a promising route to lower metallization costs and reduce reliance on silver.
The mechanical pressure and thermal treatments used in screen printing can damage the sensitive passivating contact structures of HJT cells, raising recombination losses and lowering conversion efficiency. Researchers in China investigated the mechanisms behind this degradation in copper-plated HJT cells and developed a method to mitigate the effects, according to findings published in Solar Energy. Corresponding author Lang Zhou told pv magazine that photoresist screen printing differs fundamentally from conventional silver paste printing. In silver paste printing, screen openings cover only 2–5% of the total area, while an emulsion layer covers the rest and prevents direct contact between the mesh and the wafer. Full-area photoresist coating typically uses a screen without emulsion coverage to ensure uniform resist deposition, so the mesh comes into direct and extensive contact with the wafer during each printing cycle.
Efficiency and lifetime losses
Previous investigations in commercial solar cell production showed conversion efficiency declining from 26.2% to 25.7% over 15,000 consecutive printing cycles. The losses were mainly attributed to reductions in open-circuit voltage and fill factor, while short-circuit current density and electrical resistance remained largely unchanged. Measurements showed that minority carrier lifetime degradation rose from 0.61% with a new screen to 11.0% after 15,000 printing cycles.
Using three-dimensional confocal microscopy, the scientists identified progressive wear of the screen mesh knuckles as the main cause. As the knuckles wore down, their contact area with the wafer increased, placing greater mechanical stress on the underlying passivation layers. Scanning electron microscopy revealed no visible surface scratches, but photoluminescence measurements confirmed increased recombination losses, suggesting damage to the amorphous silicon/crystalline silicon interface.
Buffer layer trade-off
To address the issue, the team developed an emulsion buffer layer to prevent direct contact between the screen mesh and the wafer surface. The researchers evaluated six patterns with emulsion coverage ratios ranging from 2.9% to 16.6%. The results showed a trade-off between mechanical protection and photoresist coating uniformity, as higher coverage reduced damage but impaired ink distribution. An emulsion coverage ratio of 4.7% provided the best balance, limiting minority carrier lifetime degradation to 0.41% after 10,000 printing cycles while maintaining relatively good coating uniformity.
The researchers attributed the improvement to the emulsion layer preventing direct contact between the mesh and the wafer, thereby reducing cumulative mechanical damage to the passivation layers. Zhou said the findings show that a relatively simple modification to screen design can substantially mitigate printing-induced degradation, offering a practical approach to improving the manufacturing reliability of copper-plated HJT cells.
Copper metallization momentum
The work comes amid growing interest in copper metallization as an alternative to silver-based contacts in HJT cells. In April 2026, researchers at China’s Nankai University developed a silver-free HJT solar cell with 25.2% efficiency using plasma-induced interface engineering and copper electroplating. The approach addressed adhesion, contact resistance and stability challenges at the ITO interface. Separately, scientists at Germany’s Forschungszentrum Jülich achieved 23.08% efficiency in a fully copper-metallized HJT solar cell. The silver-free device had a relatively small efficiency penalty compared with its silver-metallized counterpart, while cells combining silver-copper paste on the front side with silver contacts on the rear reached 23.95% efficiency. The findings underline copper’s potential to reduce silver consumption, although further improvements in processing and electrical performance remain necessary.
