Zeph Gage has developed a rear-only portal axle for his Jeep XJ at roughly one-fifth the cost of a typical set, according to the build report. The assembly combines a Ford 9-inch axle housing, geared hubs from a Humvee and HMMWV portal adapters from Jesse Haines Fabrication to raise ground clearance without the expense and packaging challenges of a conventional four-wheel portal conversion.
Portal axles are prized in hardcore off-roading because they place a stack of gears behind each driven wheel instead of letting shafts and other components hang below the transmission and transfer case. That layout allows the axle shafts to sit higher, leaving less hardware below the frame line. Tall tires then add further clearance. As Andrew Collins explains, the idea is simple in principle but delivers a major practical advantage. The drawback is cost: a typical set from companies such as 74Weld runs about $20,000. Gage’s rear unit costs about $4,000.
How the flipped differential makes it work
Two-gear portals like the Humvee units reverse the rotation of the input shaft. To correct that with a Ford 9-inch, Gage flipped the differential upside down so the driveline spins in the proper direction. A Yukon Gear and Axle third member is then bolted to the differential, effectively turning low-pinion parts into a budget high-pinion unit.
The conversion adds about six inches of clearance, but that is not its only benefit. It also retains full shock travel, which the report notes is tricky to achieve with portal axles, and reduces stress on the differential itself. The reduced stress should make the setup effectively bulletproof, according to the build report.
Why only the rear axle gets a portal
Installing a portal axle at the rear without upgrading the front is a common trick in the remote-control rock crawler scene. By keeping the solid front axle, Gage avoids the packaging constraints that usually arise when portal axles are fitted to a vehicle that never had them from the factory. He also does not have to restrict shock travel to solve those constraints, and the ride height does not become ridiculously high.
In practice, the XJ can drive over a five-gallon bucket and still have several inches of spare clearance. The report says the rear end will not get hung up on obstacles that the front end can steer around.
Custom fabrication, not a kit
The setup is not an off-the-shelf solution. Gage carried out substantial custom fabrication, including homemade brackets, custom-tapped plates and a two-piece brake rotor paired with a Ford Fusion caliper. He chose the Fusion hardware partly because it offers an integrated electric emergency brake solenoid and partly for clearance reasons.
The result is a clever, highly customized assembly that required careful development. It also shows the limits of the approach: the savings come from mixing adapted components and doing the fabrication work, not from buying a complete bolt-on portal-axle package.
